Installing a Triple D grinder pump station isn’t just a matter of digging a hole and plugging it in- it’s coordinated process that ensures wastewater get handled efficiently, especially in low-lying areas where gravity alone won’t do the trick. Here’s what’s typically involved:
Essential Components & Equipment
- Grinder Pump Package: This includes the submersible grinder pump, basin, lid, discharge piping, check valve, and control panel. Triple D Pump CO. usually provides these as a complete unit.
- Electrical Setup: A dedicated circuit (usually 240 volt) is needed to power the pump. An electrician should install a weatherproof disconnect and the control panel.
- Inlet & Discharge Piping: The system must connect to the home’s sewer line (inlet) and the municipal force main or septic system (discharge).
Site Preparation & Installation Steps
- Excavation: Dig an appropriately sized pit for the basin. Depth depends on the frost line and elevation requirements.
- Base preparation: Lay a crushed stone or concrete pad to stabilize the basin.
- Set the Basin: Lower the basin into the pit and level it. Seal any penetrations where inlet/discharge pipes enter.
- Plumbing Connection: Install inlet piping from the home and connect discharge piping with check valve and backflow protection.
- Electrical Installation: Mount the control panel and connect all wiring according to local codes.
- Inspection: Have the system checked by local plumbing/electrical inspectors.
- Final Backfill and Landscaping: Carefully backfill the area and restore any surface landscaping.
Permits & Considerations
- Local permits are typically required for electrical and plumbing work.
- Check with the municipality regarding connection fees and compliance standards.
- Always have a licensed contractor handle pump and electrical installations for safety and code compliance.
